15-22
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 15 Monitoring Ethernet Operations, Administration, and Maintenance Tool Properties
Configuring L-OAM
Enable E-LMI On Interface Interface name (if E-LMI is disabled globally, you can use
this command to enable E-LMI on specific interfaces)
Configure OAM Parameter on
Interface Configure OAM parameters, like maximum and minimum
transmission rate of OAM PDU , OAM client mode and
remote loopback ability on an interface.
Start Remote Loopback
Stop Remote Loopback
Specify the local interface name on which the remote
loopback should be started and stopped.
Command Description