12-119
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 12 Monitoring Carrier Ethernet Services Configuring REP and mLACP
Configuring REP and mLACP
The following commands can be launched from the inventory by right-clicking the a ppropriate node and
selecting Commands. Before executing any commands, you can preview them and view the results. If
desired, you can also schedule the commands. For details on the s oftware versio ns Pr ime N etwork
supports for these network elements, see the Cisco Prime Network 4.0 Supported Cisco VNEs. To run
the REP and mLACP commands, the software on the network element must sup por t the se te chnol ogy.
Additional commands may be available for your devices. New commands are often provided in Prime
Network Device Packages, which can be downloaded from the Prime Network softw are download site.
For more information on how to download and install DPs and enable new commands, se e the
information on “Adding Additional Device (VNE) support” in the Cisco Prime Network 4.0
Administrator Guide.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
REP Command
Show REP Segment
Information Commands > Show This action performed at the command
the launch point.
mLACP Commands
Show Group
Show MPLS LDP
Show Channel
Show LACP Internal
Commands > Show These actions are performed at the
command the launch point.