25-29
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies GPRS/UMTS Networks
GTPP Commands
The following commands can be launched from the inventory by right-clicking a GTPP a nd choo sing
Commands > Configuration or Commands > Show.
The table below lists the GTPP commands. Additional commands may be available for your devices.
New commands are often provided in Prime Network Device Packages, which can be downloaded f rom
the Prime Network software download site. For more information on how to download and install DPs
and enable new commands, see the information on “Adding Additional Device (VNE) support” in the
Cisco Prime Network 4.0 Administrator Guide.
Before executing any commands, you can preview them and view the results. If desired, you can also
schedule the commands. To find out if a device supports these commands, see the Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
IP Address IP address of the backup storage server.
Port UDP port number over which the GGSN communicates with the backup
storage server.
Timeout Maximum amount of time, in seconds, the system waits for a response fr om
the GTPP backup storage server before assuming the packet is lost.
Max Retries Number of times the system attempts to communicate with a GTPP backup
storage server that is not responding.
Table 25-15 GTPP Characteristics (continued)
Field Description