12-88
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 12 Monitoring Carrier Ethernet Services
Working with VPLS and H-VPLS Instances
Figure 12-51 VPLS Tunnel Properties Window
Table 12-39 describes the information that is displayed for pseudowire endpoint properties.
Table 12-39 Tunnel Properties Window
Field Description
Port VSI on which the pseudowire is configured, hyperlinked to the VSI
in logical inventory.
Peer Hyperlinked entry to the pseudowire endpoint peer pseudowires in
logical inventory.
Peer VC Label MPLS label that is used by this router to identify or access the tunnel.
It is inserted into the MPLS label stack by the peer router.
Tunnel Status Operational state of the tunnel: Up or Down.
Local VC Label MPLS label that is used to identify or access the tunnel. It is inserted
into the MPLS label stack by the local router.
Local Router IP IP address of this tunnel edge, which is used as the MPLS router
identifier.
Tunnel ID Identifier that, along with the router IP addresses of the two pseudowire
endpoints, identifies the PWE3 tunnel.
Peer Router IP IP address of the peer tunnel edge, which is used as the MPLS router
identifier.
Local MTU Size, in bytes, of the MTU on the local interface.
Remote MTU Size, in bytes, of the MTU on the remote interface.
Signaling Protocol Protocol used by MPLS to build the tunnel, such as LDP or TDP.
Pseudowire Type Type of pseudowire, such as Ethernet, Ethernet Tagged, CESoPSN
Basic, PPP, or SAToP.