Motorola DSP56000, 24-Bit Digital Signal Processor manual Jsset #n,S,xxxx

INSTRUCTION DESCRIPTIONS

JSSET Jump to Subroutine if Bit Set

Instruction Format:

JSSET #n,S,xxxx

Opcode:

JSSET

2316 158 70

0 0 0 0 1 0 1 1 1 1 D D D D D D 0 0 1 b b b b b

ABSOLUTE ADDRESS EXTENSION

Instruction Fields:

#n=bit number=bbbbb, S=source register=DDDDDD,

xxxx=16-bit Absolute Address in extension word

Source Register	D D D D D D					Bit Number bbbbb
4 registers in Data ALU	0	0	0	1 D	D	00000
8 accumulators in Data ALU	0	0	1	D D	D	•
8 address registers in AGU	0	1	0	T T	T	10111
8 address offset registers in AGU	0	1	1	N N	N
8 address modifier registers in AGU	1	0	0	F F	F
8 program controller registers	1	1	1	G G	G

See Section A.10 and Table A-18for specific register encodings.

Notes: If A or B is specified as the destination operand, the following sequence of events takes place:

1.The S bit is computed according to its definition (See Section A.5)

2.The accumulator value is scaled according to the scaling mode bits S0 and S1 in the status register (SR).

3.If the accumulator extension is in use, the output of the shifter is limited to the maximum positive or negative saturation constant, and the L bit is set.

4.The bit test is performed on the resulting 24-bit value, and the jump to sub- routine is taken if the bit tested is set. The original contents of A or B are not changed.

Timing: 6+jx oscillator clock cycles

Memory: 2 program words

MOTOROLA INSTRUCTION SET DETAILS A - 143