Program 26 : ARS Service
26-01 : Automatic Route Selection Service
Aspire Software Manual Programming ◆1141
Program 26 : ARS Service
26-01 : Automatic Route Selection Service
Description
Use Program 26-01 : Automatic Route Selection Service to define the system options for Auto-
matic Route Selection (ARS).
Input Data
Level: Aspire S Aspire M/L/XL
IN • Available. • Available.
• Option 6 available with 2.63+ software. • Option 6 available with 2.63+ software.
Item No. Item Input Data Default
01 ARS Service
Enable or disable ARS. 0 = Disable
1 = Enable 0
02 Network Outgoing Inter-Digit ARS Timer
With Networking, this timer replaces
20-03-04 when determining if all network
protocol digits have been received. If ARS is
enabled at Site B, this timer can be pro-
grammed for 5 (500 msec) at Site A. If ARS
is disabled and Site B is using F-Route for
outbound dialing, this timer should be pro-
grammed for 30 (3 seconds) at Site A.
0-64800 (msec.) 30
03 ARS Misdialed Number Handling
If a user dials a number not programmed in
ARS, this option determines if the system
should route over trunk group 1 or play error
tone.
0 = Route to Trunk
Group 1
1 = Play Warning
Tone to Dialer
1
04 LCR Mode - Not Used in the U.S. -0
06 ARS COS Match Access
With the ARS Class of Service Match
Access feature, you can determine whether
the system should allow a call based on the
COS assigned to the Dial Analysis Table
(Program 26-02). This change can be used to
create a tenant-like application. It will then
use the trunk group defined in the Additional
Entry in Program 26-02-03 to place the out-
going call.
When this feature is enabled, the calls will
be routed in sequential order, and will for-
ward provided the Class of Service for the
trunk groups match.
0 = Disabled (COS
not compared)
1 = Enabled (COS
Match Access)
0