Charts and Illustrations
32 ◆Features Aspire Software Manual
Secretary Call
Pickup Code: 42 + boss ext
Operation: Press key A secretary picking up a call
ringing your boss’s extension On red when
activated -
Selectable Display
Messaging Code: 18
Operation: Press key +
additional data if needed
Setting up Call Forwarding
Off-Premise, Selectable
Display Messaging, VRS
Park and Page and VRS
Personal Greeting
Flashes red when
activated *4
Serial Call Code: 43
Operation: Trk call +
Hold + ext + Press key
Placing a Serial Call to a
co-worker None -
Station Message
Detail Recording Code: 08
Operation: Press key TBD Flashing when new
log created
On in call log
-
Step Call Code: 36
Operation: Press key Stepping through a depart-
ment group None #
Transfer Code: 06
Operation: Establish call
+ Hold + Ext + Press key
Transferring a call None -
Trunk Group
Routing Code: *05
Operation: Press key Accessing a trunk using
Trunk Group Routing On red when active 9
Trunk Groups Code: *02 + Trk group
(1-9 or 001-200)
Operation: Press key
Using a trunk group key to
access a Trunk Group On red when active 804
Trunk Queuing Code: 35
Operation: Hear busy
tone for Trk + Press key
Camping On or Queuing for a
trunk On red while
camped on 2
Voice Response Sys-
tem (VRS) (Park
and Page) (Personal
Greeting)
Code: 17
Operation: Press key +
device type code +
requested data (depends
on device selected).
Setting up Call Forwarding
Off-Premise, Selectable
Display Messaging, VRS
Park and Page and VRS
Personal Greeting
Flashes red *4
Voice Mail Code: 68 + code (0-2)
Operation: Press key Using Voice Mail Service Flashes slowly when
monitoring -
Code: 77 + extension or
Message Center number
Operation: Press key
Calling Voice Mail or
leaving a message Flashes green on
your key for your
messages or flashes
red for the Message
Center
*8 or 8
Code: 78 + 0
Operation: Set up call +
Press key
Using Voice Mail Record Slow Flash red when
active -
Table 5: Function Key Codes by Features
To program a key, press CALL, dial 851 (for 2-digit codes) or 852 (for 3-digit codes), press the key and enter the
code (e.g., 48 for Voice Over).
For this feature... Use this key... When your are... Key Lamp Status Also See
Srvc Code