Maintenance
400 ◆Features Aspire Software Manual
➻90-11-07 : System Alarm Report - SMTP Host Port Number
Set the SMTP host port number (0-65535). Contact your ISP (internet service provider) for
the correct entry if needed. Usually, the default entry of 25 can be used.
➻90-11-08 : System Alarm Report - To Address
Set this EMail address to which the report should be sent (up to 255 characters).
➻90-11-09 : System Alarm Report - Reply Address
Set this EMail address to which any replies should be EMailed (up to 255 characters).
➻90-11-10 : System Alarm Report - From Address
Set this EMail address from which the report is being sent (up to 255 characters). This option
is required for the EMail function to work.
➻90-11-11 : System Alarm Report - DNS Primary Address
Set the DNS primary address (0.0.0.0-255.255.255.255).
➻90-11-12 : System Alarm Report - DNS Secondary Address
Set the DNS secondary address (0.0.0.0-255.255.255.255).
➻90-11-13 : System Alarm Report - Customer Name
Enter a name which will be used to identify the particular system (up to 255 characters).
➻90-25-01 : System Alarm Report CC Mail Setup
Set up to five additional destinations which can receive copies of the report.
System Information Reports
➻90-13-01 : System Information Output - Output Port Type
Define the output port to be used as the output for system information report (0=no setting,
1=NTCPU COM port, 2=NTCPU USB port, 4=CTA/CTU adapter). Set the baud rate for the
COM port in Program 10-21-02. The system can have up to 50 reports.
➻90-13-02 : System Information Output - Destination Extension Number
If the output port type (90-13-01) is a CTA, enter the extension number with the CTA connection.
➻90-13-03 : System Information Output - Output
Entering 1 will print the system report to the connected device.
Extension Data Swap/Secure Set Relocation
➻11-15-12 : Service Code Setup, Administrative (for Special Access) - Extension Data
Swap
Define the service code (up to 8 digits) to be used with the Extension Data Swap feature. By
default, there is no entry.
➻92-05-01 : Password for Extension Data Swap
This program defines the 4-digit password to be used by each extension when using the
Extension Data Swap feature using a service code (Entries: 0 - 9, *, # [Fixed at 4 digits])
➻92-04-01: Extension Data Swap
Enter the two extension numbers which should be swapped. After pressing HOLD, the system
data for the programs listed in the table above will be swapped. Any user-defined program-
ming stored in the SRAM will not be swapped (for example, Call Forward set up, Selectable
Display Messaging, etc.).
Related Features
Traffic Reports
Traffic Reports log system call data providing several reports which can be used to determine
adequate system resources (receivers, channels, trunks, etc.).