Station Message Detail Recording
528 ◆Features Aspire Software Manual
Programming (Cont’d)
Start
SMDR With a CTA Adapter
In 15-02-19, set the
extension with
the CTA Adapter to "1".
In 15-02-20, set the baud
rate to be used
for the CTA connection
(0=4800, 1=9600, 2=19200).
In 35-01-01 set the SMDR
output to "4" for CTA/CTU.
In 35-01-02, define the extension number
of the keyset with the CTA Adapter.
Set the dip switches on the CTA Adapter
to pins 1 and 2 on (up), 3-8 off (down).
Without
the line cord connected to
the keyset, install the CTA Adapter
onto the keyset.
You may wish to remove
the wall mount bracket to
allow easier installation.
Refer to the Aspire or Aspire S Hardware
Manual for further installation details on
the CTA Adapter.
Connect the line cord to the keyset.
Wait one minute for the system
to recognize the adapter.
Disconnect the phone.
Check 10-03-04 for the keyset.
Does it show the CTA installed?
The CTA Adapter
does NOT require
an AC/DC power
adapter.
No
Undefine the keyset's
port in 10-03-01.
Remove the CTA Adapter.
Connect an RS-232C straight-thru
cable to the adapter and PC.
Yes
Go to
"A".
Do Not
plug in the keyset with
the CTA Adapter.
Disconnect
the phone
and undefine
(set to 0)
the keyset's
port in
10-03-01.
Was the
extension on
which the CTA
Adapter is to be
installed
previously
connected to
the system?
Yes
No