Central Office Calls, Placing
222 ◆Features Aspire Software Manual
➻82-09-01 : SLIU CODEC Filter Data Setup
The system will use the settings in the new Program 82-09 : SLIU CODEC Filter Data
Setup when Program 82-07-01 : CODEC Filter Setup for Analog Station Ports is set to "4
- Specified Data". These values should not be changed from their default settings unless
directed by NEC’S Technical Service department.
The side tone of the COIU is adjusted using all 16 values, however, special software is
required in order to compute these values. The setting is not proportional to the gain level. To
change these values, contact NEC’s Technical Service department for assistance.
Related Features
Alphanumeric Display/Call Timer
If the trunk name seize display is enabled in programming, Call Timer starts automatically
after the user places a trunk call. Disabling the trunk name seize display also disables the Call
Timer.
Automatic Route Selection
The system can automatically select the correct type of line to use based on the number dialed
and the time.
Dial Tone Detection
Refer to this feature for the specifics on how the system handles Dial Tone Detection.
Handsfree
With Automatic Handsfree, an extension user can press a line key to place a trunk call without
first lifting the handset or pressing SPK. Users without Automatic Handsfree can preselect a
line key before lifting the handset or pressing SPK.
Long Conversation Cutoff/Warning Tone for Long Conversation
Long Conversation Cutoff can disconnect incoming and outgoing CO calls after a set time
period. Using the Warning Tone for Long Conversation feature allows users on outgoing calls
to hear a warning tone prior to the call disconnecting.
Loop Keys
Loop keys simplify placing Central Office Calls.
Microphone Cutoff
In order to mute the handset transmitter, set up a Microphone Cutoff Programmable Function Key.
The MIC key will only mute the handsfree microphone.
Programmable Function Keys
Line keys and loop keys simplify placing outside calls.
Toll Restriction
An extension’s Toll Class of Service may prevent them from dialing certain numbers.
Trunk Group Routing
Trunk Group Routing sets outbound call routing options for users that dial the Trunk Group
Routing code (9) for trunk calls.
Trunk Groups
Use trunk group programming to set the order in which users access trunks within a specific
trunk group.