Program 91 : Aspire Wireless Subscription
91-06 : Aspire Wireless Subscription, New
1548 ◆Programming Aspire Software Manual
Telephone Programming Instructions
To enter data for Program 91-06 (Aspire Wireless Subscription, New):
1. Enter the programming mode.
2. 90 27
3. To have the system automatically assign a port number to the phone, press “0” then HOLD.
This assigns an available port within the range of 385-512.
To manually select a port number, enter an available port number (002-512) then press
HOLD.
The display shows IPEI?. The IPEI (International Portable Equipment Identity) is a
unique number embedded into each Aspire Wireless phone.
4. Enter the IPEI number for the Aspire Wireless phone or enter * as a wild character and the
system will automatically retrieve the number for the phone being set up. Press HOLD. When
the display shows “Ready?(1:Yes)”, press 1 then HOLD.
The IPEI number is the 13-digit serial number which is located on the label in the
phone’s battery compartment.
5. The display shows the port number assigned to the phone and the 4-digit AC (Authentication
Code) number. DO NOT PRESS HOLD at this point or the subscription will be cancelled.
6. Using the Aspire Wireless phone to be registered, press the Menu key then press the Left
Arrow key twice to display the Login option. Press OK.
7. Press the Right Arrow key once to display the Subscription Create option. Press OK.
8. The Aspire Wireless phone will search for the DSIU PCB and display the PCB’s ID number
once found.
This may take a few seconds. If the ID number does not appear, check Program
90-27-01 to make sure the PCB is recognized.
9. Press OK.
10. Enter the 4-digit AC number displayed in Step 4 (Program 91-06-01) and press OK.
11. Once the phone has been registered, the phone will beep and (((.))) will appear in the lower
left-hand corner. Program 91-06-01 will now show COMPLETED. Press HOLD and register
another phone if required or continue with the next step.
Prior to deleting an Aspire Wireless (DECT) phone from the system using Program
91-07-01 : DECT Subscription - Delete, make sure the DSIU PCB is installed in the sys-
tem. If the DSIU is removed when Program 91-07-01 is run, the system will retain the
DECT setting. This will prevent the Aspire Wireless phone(s) from being registered in the
system again.
12. Press MSG until you’ve exited that series’s programming section.
90-27-01
Port(0:Auto)?
back ↑↑
↑↑ ↓↓
↓↓ select