Trunk Group Routing
Aspire Software Manual Features 595
Trunk Group Routing
Description
Trunk Group Routing sets outbound call routing options for users that dial the Trunk Group Rout-
ing code (9) for trunk calls. Trunk Group Routing routes calls in the order specied by system pro-
gramming. If a user dials 9 and all trunks in the rst group are busy, the system may route the call
to another group. When you’re setting up your system, Trunk Group Routing will help you mini-
mize the expense of toll calls. For example, if your system has outbound WATS lines, OCC lines
and DDD lines, use Trunk Group Routing to route calls to the WATS lines rst.
Conditions
None
Default Setting
Enabled. All trunks are in Group 1.
Programming
11-01-01 : System Numbering
Set up a Service Code for Alternate Trunk Route Access.
11-09-01 : Trunk Access Code
If required, change the single-digit Trunk Access Code (normally 9). If you change this code,
you must also review the settings in 11-01 for the new code selected.
11-09-02 : Trunk Access Code - Alternate Trunk Route Access Code
Assign the Service Code set up in 11-01 for Alternate Trunk Route Access.
14-05-01 : Trunk Groups
Assign trunks to trunk groups.
Aspire S Trunk Groups: 1-8
Aspire Trunk Groups: 1-100
14-06-01 : Trunk Group Routing
Set up an outbound routing table for trunk groups assigned in Program 14-05.
Aspire S Trunk Group Routes: 1-8
Aspire Trunk Group Routes: 1-100
14-07-01 : Trunk Access Map Setup
Access Map programming may limit Trunk Group Routing options.
Aspire S: Trunk Access Maps 1-8
Aspire: Trunk Access Maps 1-200
Aspire S Aspire M/L/XL
Available - 8 trunk groups and 8 routes. Available - 100 trunk groups and 100 routes.
OCC
Moderately
Expensive
WATS
Least Expensive
DDD
Most Expensive
Third ChoiceSecond ChoiceFirst Choice
Outbound Call
Route 1 Route2 Route 3