Automatic Route Selection
140 ◆Features Aspire Software Manual
With Program 26-01-06: ARS COS Match Access disabled (set to '0'):
●If at 9:00 AM, each extension dialed '9+(203)926-5400'
All Extension would use Trunk Group 3
●If at 9:00 AM, each extension dialed '9+(214)262-2000'
All Extension would use Trunk Group 1
●If at 6:00 PM, each extension dialed '9+(203)926-5400'
All Extension would use Trunk Group 3
●If at 6:00 PM, each extension dialed '9+(214)262-2000'
Extension 301, 302 and 401 would use Trunk Group 1
Extension 402 would not be able to dial out as the COS is lower
With Program 26-01-06: ARS COS Match Access enabled (set to '1'):
●If at 9:00 AM, each extension dialed '9+(203)926-5400'
Extension 301 would use Trunk Group 1
Extension 302 would use Trunk Group 2
Extension 401, 402 would use Trunk Group 3
●If at 9:00 AM, each extension dialed '9+(214)262-2000'
Extension 301 would use Trunk Group 1
Extension 302 would use Trunk Group 2
Extension 401, 402 would use Trunk Group 3
●If at 6:00 PM, each extension dialed '9+(203)926-5400'
Extension 301 would use Trunk Group 1
Extension 302 would use Trunk Group 2
Extension 401, 402 would use Trunk Group 3
●If at 6:00 PM, each extension dialed '9+(214)262-2000'
Extension 301, 302 would use Trunk Group 1
Extension 401 would use Trunk Group 3
Extension 402 would not be able to dial out as the COS does not match
Alternate Carrier Access Added for ISDN Trunks
An option is available which allows the system to provide a Transit Network Selection information
element for ARS calls using ISDN trunks. This information element identifies a requested transit
network. This function is valid only for outbound calls by ISDN trunk.
Local calls do not need Network Selection information since they will be handled by the local
exchange carrier (ILEC). If this is the case, ARS is able to distinguish between local and long dis-
tance calls and add the Transit Network Selection information element when required.
This option would apply to both PRI and BRI ISDN trunks. If the trunk in the used in Program 26-
02 : Dial Analysis Table for ARS/LCR is not an ISDN trunk, this code in the dial treatment will be
ignored.
The examples below use the following system programming: