Central Office Calls, Answering
Aspire Software Manual Features ◆211
Default Setting
Enabled.
Programming
➻10-03-03 : PCB Setup, For SLIU Unit - Transmit CODEC Gain Type
10-03-04 : PCB Setup, For SLIU Unit - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for 500/2500 type single
line telephones.
➻10-08-01 : Pre-Ringing Setup
Enable (1) or disable (0) pre-ringing for outside calls. This setting affects all system trunks.
➻11-10-32 : Service Code Setup (for System Administrator) - Set Private Call Refuse
Define the service code to be used to set the “Private” call refusal for the trunks which are pro-
grammed in Program 14-01-27 to 1.
➻11-10-33 : Service Code Setup (for System Administrator) - Enter Caller ID Refuse
For keysets only, define the service code to be used to add or delete the Caller ID numbers to
be refused.
➻11-10-34 : Service Code Setup (for System Administrator) - Set Caller ID Refuse
Define the service code to be used to enable/disable the Caller ID call refusal for the trunks
which are programmed in Program 14-01-27 to 1.
➻11-11-13 : Service Code Setup (for Setup/Entry Operation) - Display Language Selection
for Keyset
Select the service code which can be used at an extension to change the displayed language on
a keyset’s display (default: 178).
➻11-11-37 : Service Code Setup (for Setup/Entry Operation) - Adjusting Ring Volume
If required, change the service code used to adjust the ringing volume for CO and ICM calls
(829).
➻11-12-30 : Service Code Setup (for Service Access) - Specified Trunk Answer
If required, redefine the service code used to answer a specific trunk which is either ringing or
on hold (default: 172).
➻13-04-03 : Abbreviated Dialing Number and Name - Transfer Mode/Deesintation Number
When using Flexible Ringing by Caller ID, use this program to determine how the incoming
call should be handled (0=not defined, 1=rings an internal number, or 2=rings an incoming
ring group).
If this option is set to 1 or 2, then determine the number or ring group to be dialed. With inter-
nal dial (1), enter the digits to be dialed (up to 24 including 0-9, *, #, P, R, @). With the ring
group (2), enter the ring group to which the call should be sent.
➪Aspire S Ring Groups: 1-8, 102=In-Skin/External Voice Mail, 103=Centralized Voice Mail
➪Aspire Ring Groups: 1-100, 102=In-Skin/External Voice Mail, 103=Centralized Voice Mail
➻13-04-05 : Abbreviated Dialing Number and Name - Incoming Ring Pattern
Determine the ring pattern to be used ( 0 = normal pattern, 1-4 = tone pattern 1-4, 5-9 = scale
pattern 1-5) for Caller ID Refusal. The definition of the tone pattern is the same as Program
22-03.
➻14-01-02 : Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 : Basic Trunk Data Setup - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for each trunk.
➻14-02-02 : Analog Trunk Data Setup - Ring Detect Type
For each trunk, enable delayed ringing (0) or immediate ringing (1).