Cordless II/Cordless Lite II Telephones
Aspire Software Manual Features ◆253
Hold on CO Calls No Longer Immediately Recalls
The operation of the Cordless II and Cordless Lite II phones have been enhanced when placing an
outside call on hold.
With older software, if an outside caller was placed on hold by a Cordless II/Cordless Lite II user
and the user then pressed the TALK button to hang up, the call would immediately recall the user.
With software 4.0V+, if the phone has a line key (Program 15-07-01 or SC 851: *01) or a loop key
(Program 15-07-01 or SC 851: *02 or *05) programmed, the call will remain on hold and recall
only after the hold recall timer has expired (Program 24-01-01). However, without these keys (with
software 4.0V only), when placing a call on hold and pressing the TALK button to hang up, the call
would immediately ring back.
Software 4.0W further enhances the operation so that a user without a line or loop key programmed
can place a caller on hold and press the TALK button. The call will remain on hold and recall only
after the hold recall timer has expired (Program 24-01-01).
Intercom calls will still recall immediately if the Cordless II/Cordless Lite II user presses TALK
after placing an internal call on hold.
Conditions
(A.) The Cordless phone must be set to ringing mode - not voice announce once it is installed using
service code 823.
(B.) Programs 15-02-02 : Multi-Line Telephone Basic Data Setup, Trunk Ring Tone and 15-02-
03 : Multi-Line Telephone Basic Data Setup, Extension Ring Tone are ignored as the
phone follows its programmed setting and not the system setting.
(C.) The Cordless phone can only display alphanumeric characters. Therefore, if any other lan-
guage other than English is selected in 15-02-01, the display may not function correctly.