Program 34 : Tie Line Setup
34-09 : ANI/DNIS Service Options
Aspire Software Manual Programming ◆1217
04 Route Table Setup of Target Dial
The option sets how the system uses the route
data (gathered in Item 3) to route incoming
ANI/DNIS calls).
If option ‘2’ is selected and the call is to be
routed using the DID table (1), up to 8 digits
can be matched. The number of expected dig-
its set in Program 22-09-01 must match the
ANI digits defined in Program 22-11-01. For
example, if an ANI/DNIS number received
was *2035551234*3001* and Program
22-09-01=4, then the entry in 22-11-01 must
be 1234 with the defined target extension.
If the call is to be routed using the ABB table
(0), up to 24 digits can be matched. Define the
range of the ABB table to be used in Program
34-09-06. The data is then compared to the
entries in Program 13-04-01 and then routed
according to Program 13-04-03.
0 = ABB Table
(Program 13-03)
1 = DID Table
(Program 22-11)
0 0 13-04-01
13-04-03
22-09-01
22-11
34-09-05
34-09-06
05 ANI/DNIS Display as Target Dial Name
Use this option to set if ANI data should
appear on telephone displays as part of Caller
ID display.
0 = Display Off
1 = Display On 1 0 13-04
20-09-02
22-11-03
23-09-04
06 Routing ABB Table Setup
Use this option to define which part of the
ABB Table set up in Program 13-04 the sys-
tem will use for ANI/DNIS Caller ID look-ups
and ANI/DNIS routing.
This is required if Items 4 and 5 above are 1
(Caller ID on). When you specify a starting
and end address, the system uses the part of
the table for look-ups.
When you specify a starting address and
length, the system uses that part of the table
for routing. If the incoming ANI/DNIS num-
ber data matches the Number entry in the
table, the system routes according to the asso-
ciated Name data. That data can be an exten-
sion, Department Group pilot number, the
voice mail master number or a trunk ring
group.
Start = 0, 100-1900
End = 0, 99-1999 Start = 1000
End = 1199 Start = 0
End = 0 13-04
07 Routing on ANI/DNIS Error
This option lets you determine how the sys-
tem will handle an ANI/DNIS call if a data
error is detected in the incoming data string.
0 = Play busy tone to
caller
1 = Route the caller to
the ring group speci-
fied in Program 25-03
1 0 25-03
Item
No. Name Input Data
Default Related
Program
COS 01-14 COS 15