Program 26 : ARS Service
26-03 : ARS Dial Treatments
Aspire Software Manual Programming ◆1145
26-03 : ARS Dial Treatments
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS
dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
●3 - Delete the NPA if dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
●2 - Delete the leading “1” if dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
●1 - Add a leading 1 if not dialed as part of the initial call.
Requires at least 8 digits in the ARS table (Program 26-02-01).
●INPA - Insert the NPA specified by NPA.
●DNN - Outdial the NN number of digits or execute the code that follows. For example,
D041234 out-dials 1234. Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause).
Each digits code counts as a digit. So for example, if a P was added for a pause, the entry
would look like: D05P1234. This Dial Treatment can only be added from telephone program-
ming.
●Wnn - Wait nn seconds.
●P - Pause in analog trunk.
●R - Redial the initially dialed number, including any modifications
●E - End of Dial Treatment. All Dial Treatments must end with the E code.
●X - When ARS is enabled, X must be entered in the Dial Treatment in order for the system to
output the extension number of the call’s originator to the black box for the E911 feature.
●An - For Alternate Carrier Access (n = 1 ~ 4). The numeric digit instructs the system to insert
a Transit Network Selection information element in the SETUP message and also identifies
which code in Program 26-11 will be included in the information element. This function is
valid only for outbound calls by ISDN trunks.
Input Data
Conditions
None
Level: Aspire S Aspire M/L/XL
IN • Available. • Available.
• “An” Dial Treatment available with 2.64+
software. • “An” Dial Treatment available with 2.64+
software.
Dial Treatment Table Number 1-15
Item No. Input Data Default
01 24 characters maximum No Setting