Cordless II/Cordless Lite II Telephones
258 ◆Features Aspire Software Manual
Operation
Programming the four function keys on the phone (additional key setup can also be
done in the system programming):
1. At the same time, press and hold *# then press TALK.
‘F1=LK01’ shows in the display and the F1 LED flashes red.
2. Press MUTE to select the function/line key to program.
LK01 - LK04 and Off-Hook Ring.
3. Press R/VOL repeatedly to scroll options for each line key.
LK01 - LK16. Use the Aspire programming to define keys for any feature use.
4. Press TALK to exit programming mode.
When initially installed, the 4 function keys default to line keys 1-4 respectively and
off-hook ringing defaults to ON.
Programming the Redial Key to Activate the Cordless Phone:
This option can only be used on the Cordless II.
1. Make sure the Base Unit is in DESK mode. If the DESK LED is not lit, press DESK button on
the Base Unit.
2. Remove the battery.
3. Press and hold *# on the handset at the same time.
4. Install the battery while pressing these keys.
5. After the handset beeps, release the keys.
The phone is now in the setup mode.
6. Press HOLD to display the current mode.
The display shows ID 0BD1 DIGITAL (REDIAL).
7. Press F2 + HOLD.
The display shows DIGITIAL (F8).
8. Press TALK to restore the phone to standby mode.
Restore the Redial function by entering setup mode, pressing F3 and then HOLD.
Switching the Extension Port from Cordless to Keyset or Vice Versa:
This option can only be used on the Cordless II.
This must be done when the phones are idle otherwise an active call will be disconnected.
1. With the phone in an idle state, press either the CORDLESS or DESK button on the base unit.
Wait a few seconds for the phone to initialize before attempting to place a call.
The LED on the Base Unit indicates which phone is currently active.
If the Cordless phone is active, the time and date are indicated on its display. If the
Aspire keyset is active, the display shows “DESK TEL”.
If programmed, the REDIAL key can be used to switch from Desk to Cordless mode
only. By default, the REDIAL key performs the redial function.