T1 Trunking (with ANI/DNIS Compatibility)
Aspire Software Manual Features ◆541
Related Features
Caller ID
An extension’s Class of Service (Program 20-09-02) determines whether ANI information is
displayed.
Central Office Calls, Answering and Central Office Calls, Placing
You can use T1 trunks in place of standard analog trunks. The procedures for placing and
answering calls are the same for both types of trunks.
Dial Tone Detection
Refer to this feature for the specifics on how the system handles Dial Tone Detection.
Direct Inward Dialing (DID)
The T1/PRI Interface PCB provides DID service. All programming parameters are the same
as those used for analog DID trunks (except for the additional T1/PRI Interface PCB settings).
ISDN
The T1/PRI Interface PCB is switch selectable between T1 and PRI operation. Refer to the
ISDN PRI Manual, P/N 0893212, for more details on PRI.
Networking
The T1 tie line can be used for Networking. Refer to the Networking Manual, P/N 0893207,
for more details.
Station Message Detail Recording
SMDR can print trunk port names or received dialed number for ANI/DNIS or DID trunks. If
enabled in programming, DNIS digits can be printed on the SMDR reports instead of the
trunk name.
Tie Lines
The T1/PRI Interface PCB provides tie line service. All programming parameters are the same
as those used for analog tie lines (except for the additional T1/PRI Interface PCB settings).
Toll Restriction
T1 trunks follow tie line toll restriction programming (34-01-05 and 34-08) unless using soft-
ware 2.65 or higher. A new operation is available in higher versions wich allow you to select
normal toll restriction for T1 trunks.
Operation
Refer to the following features:
Central Office Calls, Answering
Central Office Calls, Placing
Direct Inward Dialing (DID)
Tie Lines