NEC 5 ,

VoIP

Aspire Software Manual Features ◆651

These programs are always required with the VoIP feature. Refer to the following feature options

for additional programming.

➻10-12-01 : NTCPU Network Setup - IP Address

Select the IP address for the IP connection (default: 172.16.0.10). A static IP address is

required by the NTCPU. The system must be reset in order for the change to take effect.

➻10-12-02 : NTCPU Network Setup - Subnet Mask

Select the Subnet Mask to be used by the IP server (default: 255.255.0.0).

➻10-12-03 : NTCPU Network Setup - Default Gateway

If required, select the default gateway IP address to be used when using a router

(default: 0.0.0.0).

In addition to the system programming for the NTCPU or VOIPU PCB, the IP phone also has

options which must be programmed from the phone itself. Be sure to set both the system and phone

options.

➻10-13-01 : In-DHCP Server Setup - DHCP Server Mode

Disable (0) the system’s ability to use the built-in DHCP server.

➻84-04-01 : VOIPU PCB DHCP Server Mode Setup

Disable (0) the use of DHCP for the VOIPU PCB.

➻84-05-01 : VOIPU IP Address Setup - IP Address

For each VOIPU PCB, enter the IP address for the VOIPU PCB (default: slot 1=172.16.0.20,

slot 2 = 172.16.0.21, etc.). The IP address should be increased according to the number of

VOIPU PCBs. This entry becomes invalid if Program 84-04 is set to "1" (DHCP enabled).

➻84-06-01 : VOIPU Setup - RTP Port Number

For each VOIPU PCB, enter the RTP port number (default 10020).

Programming - Aspire IP Keyset or Aspire Keyset with IP Adapter, Static IP Address

Setting the IP Address on an Aspire IPhone or Aspire Keyset with IP Adapter Using a

Static IP Address

1. On the Aspire IP keyset, enter the phone’s program mode by pressing HOLD CONF * #.

This enters the IP User Menu program mode to select the settings for the individual

phone.

To enter the phone’s program mode, the display must show the time, error, or “Con-

necting” message prior to pressing HOLD CONF * #.