Page 170 of 910 Features
553-3001-365 Standard 4.00 August 2005
Note: An IP address of 0.0.0.0 means the default local Echo Server will
be enabled.
If IP addresses are specified, they must be for servers external to the system.
The IP addresses cannot be the same. Duplicate IP addresses can only be used
if the default of 0.0.0.0 is used. If the IP addresses are the same (and not
0.0.0.0), an error message is generated and the input is not accepted.
IMPORTANT!
The NAT Traversal feature is essentially automatic. Changing the IP
addresses or ports should only be done in exceptional cases when an
Echo Server external to the CS 1000 system is used.
Table 28
LD 117 commands for NAT (Part 1 of 2)
Command Description
CHG ES1 <Echo Server 1 IP
Address> <Echo Server 1 Port>
Change Echo Server 1’s IP address and port number,
where:
• Default Echo Server 1 IP Address = 0.0.0.0
• Default Echo Server 1 Port number = 10000
Note: Echo Server 1 default IP address uses the TLAN
IP address of the LTPS.
CHG ES2 <Echo Server IP
Address> <Echo Server Port>
Change the Echo Server 2 IP address and port number,
where:
• Default Echo Server 2 IP Address = 0.0.0.0
• Default Echo Server 2 Port number = 10000
Note: Echo Server 2 default IP address uses the
node IP address on the node’s master card.
PRT ES1 Print Echo Server 1’s IP address and port number.
PRT ES2 Print Echo Server 2’s IP address and port number.
PRT ESS Print both Echo Servers IP addresses and port numbers.