Page 480 of 910 Configuration of IP Telephony nodes using OTM 2.2
553-3001-365 Standard 4.00 August 2005
Figure 152
Specifying additional ELAN subnet routes
8Click OK to exit the window.
End of Procedure

Configure node synchronization with the Call Server

The SNMP MIB II parameters are configured as a node property in the group
box “SNMP parameters” on the New Node - General tab. See Figure 153 on
page 481.
The check box enables/disables synchronization of the SNMP parameters
with the Call Server. The default value is selected. During Update System
Data, the SNMP parameters are propagated to all existing IP nodes that have
the “Synchronize with PBX system” option selected. Status of the node is set
to changed (CHG).
In this diagram, an additional ELAN route is required to
reach the management workstation, which is accessible
throu
g
h the ELAN network interface but is not on the ELAN subnet.
Management
Workstation
Meridian 1 or CS 1000
TLAN route /
default route
ELAN route +
additional routes
ELAN
subnet
TLAN
subnet
Some
other
LAN