Page 444 of 910 Configuration of IP Telephony nodes using Element Manager
553-3001-365 Standard 4.00 August 2005
Figure 134
Firmware Upgrade Progress – finished
11 Repeat the preceding steps for all the card(s) that have to be upgraded.
The IP Phones continue to run the old firmware until each IP Phone
reregisters with a Voice Gateway Media Card containing the new
IP Phone firmware.
Note: Commands are available from the IPL> command line to upgrade
a single IP Phone immediately, all IP Phones immediately, or schedule all
IP Phones to be upgraded at a later time. Before doing this, verify that
each Voice Gateway Media Card has the correct IP Phone firmware
version.
12 Select an IP Phone for test purposes.
13 Telnet to the Voice Gateway Media Card and then log into the IPL>
command line, and enter the following:
isetReset “xxx.xxx.xxx.xxx”
where xxx.xxx.xxx.xxx is the IP Address of the selected telephone.
14 Monitor the display on the test telephone. As the IP Phone upgrades the
firmware, note the IP Address of the Voice Gateway Media Card from
which the telephone is receiving its upgrade.
15 Press the Services key (key with globe with arrow pointing East and West
on the IP Phone 2002/IP Phone 2004). The Services key enables access
to the Telephone Options list.
a. Press Select to select Telephone Options.
b. Use the Navigation keys to scroll to Set Info.