IP Line 4.5 administration Page 559 of 910
IP Line Description, Installation and Maintenance

IP configuration commands

Table 76 describes the IP configuration commands.

TLAN network interface configuration commands

Auto-negotiate mode can be disabled if the ports on some data network
switches and routers are manually configured. For example, configuring a
port for 100BaseT full-duplex can disable auto-negotiation on the signaling
link.
The Voice Gateway Media Card and the IP Phone default to half-duplex
mode when no auto-negotiation signaling occurs. The result is that the Voice
Gateway Media Card and the IP Phone operate in half-duplex mode, while the
switch is in full-duplex mode. Communication continues, but random packet
loss can occur which affects the correct operation and voice quality.
Table 76
IP configuration commands
IP configuration
command
Function
setLeader Performs all the necessary actions to make a
Leader. Sets IP address, gateway, subnet mask,
boot method to static, and Leader bit in NVRAM.
clearLeader Clears the Leader info in NVRAM and sets the
boot method to use BOOTP, thus, making the
card a Follower.
NVRIPShow Prints the values of the IP parameters that reside
in NVRAM.
IMPORTANT!
Configure ports for auto-negotiation, auto-sense.