IP Line administration using OTM 2.2 Page 681 of 910
IP Line Description, Installation and Maintenance
Note 2: To view the configuration of a node without overwriting the
current node configuration in OTM, retrieve the information to a dummy
node.
End of Procedure

Add an IP Telephony node in OTM by retrieving an

existing node

Use this optional procedure in the following cases:
• to add existing nodes to a particular OTM PC to manage the
IP Telephony network from a single point of view
• to restore the IP Telephony configuration database to an OTM PC whose
hard drive has crashed, as an alternative to restoring the OTM IP
Telephony nodes from the OTM Disaster Recovery Backup
When the IP Telephony node is installed and configured manually, that node
can then be added to another OTM PC by retrieving the configuration data
from the existing IP Telephony node.
Configure the site name, system name, and customer number in the OTM
Navigator before adding a new IP Telephony node. Only one IP Telephony
node can be added in the OTM IP Line application for each system customer.
If multiple OTM PCs are used to manage the same IP Telephony network,
care must be taken to synchronize the different copies of the IP Telephony
database. The OTM Configuration > Synchronize > Retrieve function can
be used to synchronize the OTM IP Telephony database with the database on
the IP Telephony node.
CAUTION
This procedure is not supported for a node that resides
on a CS 1000 system.