Configuration of IP Telephony nodes using OTM 2.2 Page 503 of 910
IP Line Description, Installation and Maintenance
To establish communication with the Leader 1 or Follower cards in the IP
Telephony node, perform the following actions:
a. Verify the TLAN physical and logical connections on all the
non-responsive cards. Ensure the following:
i. cables are plugged securely into the correct TLAN connection
ii. switch is connected to correct TLAN router
iii. remote OTM can communicate with TLAN router
b. If remote OTM 2.2 cannot communicate using the TLAN router,
connect to the Voice Gateway Media Card maintenance port with a
TTY and use the IPL> routeAdd command on each Voice Gateway
Media Card to add a new IP route through the management gateway
that points to the remote OTM PC subnet.
c. Repeat step b if the card is reset before OTM successfully transmits
the card properties (containing the SNMP Manager IP addresses and
the card routing IP addresses).
4When Leader 1 and all Follower cards show a status of disabled, click
Configure > Synchronize > Transmit. When the Transmit window
opens, click the Transmit to selected nodes radio button. Select the
Card properties to all disabled cards check box.
5Click Start transmit. Carefully monitor the progression in the Transmit
Control window. Confirm that the card properties are successfully
transmitted to every Voice Gateway Media Card in the selected node
identified by its TN
6Verify that all Voice Gateway Media Cards in the node have established
a signaling link to the Call Server.
End of Procedure