IP Line administration using OTM 2.2 Page 661 of 910
IP Line Description, Installation and Maintenance

Change the IP addresses of an IP Telephony node in OTM

Before changing any IP address, understand “Codecs” on page 287, and
consult with the IP network administrator. IP address configuration changes
are completed on four tabs in the Node Properties window as follows:
• General tab – Network connections are configured in this tab.
See Figure 224 on page 662.
• Configuration tab – Card properties are configured in this tab.
See Figure 225 on page 664.
• SNMP Traps/Routing and IPs tab – SMNP traps and card routing table
entries are configured in this tab.
See Figure 226 on page 666.
• Ports tab – ELAN network interface settings are configured in this tab.
See Figure 227 on page 668.
To change the IP address of an IP Telephony node, follow the steps in
Procedure 96.
Procedure 96
Changing the IP addresses of an IP Telephony node in OTM
1In the OTM Navigator window, click the Services folder. Double-click the
IP Telephony icon.
The IP Telephony window opens.
2Select the node in the upper portion of the window.
3Select the card in the lower portion of the window.
4Click Configuration > Node > Properties to update the Voice Gateway
Media Card IP addresses as required.
The Node Properties window opens.
CAUTION
This procedure is not supported for a node that resides
on a CS 1000 system.