Configuration of IP Telephony nodes using OTM 2.2 Page 489 of 910
IP Line Description, Installation and Maintenance
Procedure 58
Configuring SNMP trap destinations for an IP Telephony node
1Click the SNMP Traps/Routing and IPs tab in the Node Properties
window. See Figure 151.
Figure 158
Node Properties – SNMP Traps/Routing and IPs tab
2On the left side of the window, under SNMP traps:
a. Enable SNMP traps: Select the Enable SNMP traps check box, if
configuring one or more destination SNMP management IP
addresses to receive SNMP traps from cards in the IP Telephony
node.
b. IP address: If SNMP traps are enabled, this is the IP address of the
destination where the SNMP traps are sent.