Page 498 of 910 Configuration of IP Telephony nodes using OTM 2.2
553-3001-365 Standard 4.00 August 2005
When the display reads “T:20”, it begins to send BootP requests on the
ELAN subnet. A series of dots is printed on the TTY.
If the card does not display “T20”, or has stopped printing the series of
dots on the TTY, reboot the card and wait for “T20” to be displayed.
4Type +++ to escape from the BootP request.
5At the Login prompt, enter the default user ID and password of itgadmin
and itgadmin to access the IPL> CLI:
itg Login: itgadmin
Password: itgadmin
6When the maintenance window displays “T:21”, at the IPL> prompt, enter:
setLeader “xx.xx.xx.xx”,“yy.yy.yy.yy”,“zz.zz.zz.zz”
The three parameters must each be enclosed in double quotation marks.
Ensure that there is a space after the command and before the first
parameter. Put commas and no spaces between the following
parameters:
“xx.xx.xx.xx”=IP address.
Enter the same IP address that was entered in the Management LAN
IP field for Leader 0 in the Configuration tab of the Node Properties
window.
“yy.yy.yy.yy”=Gateway IP address.
Enter the same address that was entered in the Management LAN
gateway IP field in the General tab of the Node Properties window.
If there is none, enter the following: “0.0.0.0”
“zz.zz.zz.zz”=Management LAN subnet mask.
Enter the same address that was entered in the Management LAN
subnet mask field in the General tab of the Node Properties window.
Note: This step assumes that the new IP Telephony node has already
been configured in OTM 2.2.
7Reboot the Leader 0 Voice Gateway Media Card. At the IPL> prompt,
enter: cardReset, or press the Reset button on the faceplate of the
Leader 0 Voice Gateway Media Card.
8Check the maintenance display for T:22 to confirm a successful reboot.