Nortel Networks 1000 - page 554

Page 554 of 910 IP Line 4.5 administration
553-3001-365 Standard 4.00 August 2005
Pwd – this is the Administrator IP Phone Installer Password. In the default
state, the Administrator password is null (zero-length).
TmpPwd – this is the temporary IP Phone Installer Password. In the
default state, the temporary password is null.
Uses – the Uses parameter applies to the temporary IP Phone Installer
Password. In the default state, this setting is null. If the card is not in the
default state, the Uses parameter is a numeric value from 0 –1000. This
number specifies the remaining number of uses for the temporary
password. If zero is entered for the Uses parameter when setting the
temporary password, the Time parameter is mandatory. When the Time
parameter is in effect, the password expiration is based on time instead
of the number of uses.
Timeout – the Timeout heading corresponds to the Time parameter of the
temporary IP Phone Installer Password. In the default state, the Time is
null. If the card is not in the default state, this setting specifies the duration
in hours in which the temporary password is valid. The range is 0 – 240
hours (which is a maximum of 10 days). The number specified under
Timeout indicates the remaining time to expire of the temporary
password. The Time parameter is optional if the Uses parameter is
non-zero. The Time parameter is mandatory if the Uses parameter is set
to zero.
Note: If both the Uses and Time parameters are entered, the password
expires based on whichever happens first; that is, the number of Uses is
reduced to zero or the Time has expired. If both the Uses and Time
parameters are entered and are set to zero, it is the same as not
configuring the temporary password.
3Configure the Administrator IP Phone Installer Password.
The nodePwdSet <“password”> command enables and configures the
administrator password. The <password> parameter can be null, or 6 to
14 digits in length. The valid characters are 0-9 * #. This command can be
entered at any time. The new password entered simply overwrites the
previous password.
Configure the password, first with a null password and then with a
password specified.
4Type nodePwdSet at the IPL> prompt.
Note that no password parameter is specified.