IP Line administration using OTM 2.2 Page 659 of 910
IP Line Description, Installation and Maintenance
7Click OK.
Next, transmit the node properties.
8In the IP Telephony window, click the Configuration > Synchronize >
Transmit.
The Transmit Options window opens.
9Select the Transmit to selected nodes radio button.
10 Select the Node Properties to Active Leader check box.
11 Click the Start transmit button.
Monitor progress in the Transmit Control window. Confirm that the node
properties are transmitted successfully to Leader 0.
12 When the transmission is complete, click the Close button.
13 Remove the Voice Gateway Media Card.
14 Remove the Voice Gateway Media Card configuration data from the Call
Server.
a. Identify the TN of the Voice Gateway Media Card.
b. In LD 20, enter the LTN (List Terminal Number) command where
TYPE = VGW to list the TNs on the Voice Gateway Media Card TN.
This returns a list of units equipped on the card. Verify the number of
units that are equipped on the card. Take note of the first unit
equipped on the card.
c. In LD 14, use the Out n command, where n equals the number of
units that are equipped on the card.
15 At the TN prompt, enter the TN for the first unit that was equipped on the
card, as determined in Step 15 in Procedure 93 on page 651. As the units
are deleted, verify that the intended units are “outed”.
End of Procedure

CAUTION WITH ESDS DEVICES

Follow the anti-static procedures and place the Voice
Gateway Media Card in an appropriate anti-static
package.