Page 558 of 910 IP Line 4.5 administration
553-3001-365 Standard 4.00 August 2005
Procedure 71
Resetting the user name and password to default
1Connect a terminal to the Maintenance port (labeled Maint) either directly
or through a dial-up modem. The terminal communication parameters
must be as follows:
• 9600bp
• 8 data bits
• no parity
• 1 stop bit
2Press the Enter key on the keyboard.
The IPL> prompt is displayed.
3Reboot the card by pressing the RESET button on the faceplate of the
card with a pointed object, such as a ball-point pen.
4Start up messages are displayed on the terminal. Type jkl on the terminal
keyboard when the prompt is displayed.
Note: jkl runs from BIOS or boot ROM which is printed early in the
bootup process. There is only a six second window at the prompt to enter
jkl. If the prompt is missed, restart the card and repeat the above step.
5Once the card has booted from BIOS or boot ROM, a CLI prompt such as
the BIOS> appears. Enter the following command:
shellPasswordNvramClear at the prompt.
6Type reboot at the prompt to reboot the card.
7Wait for the card to completely reboot into the IP Line 4.5 application.
The password synchronization feature changes the password on the card
automatically.
End of Procedure
WARNING
Do not use a pencil to reset the Voice Gateway Media
Card. The graphite carbon can create an electrical short
circuit on the board.