Nortel Networks 1000 Transfer files using the CLI

IP Line 4.5 administration Page 567 of 910

IP Line Description, Installation and Maintenance

— A value of two (2) indicates that log messages are printed as packet

loss is detected during the call. A message is printed each time

packet loss is detected indicating how many packets where lost at

that moment.

•itgPLThreshold xxx – this command sets the packet loss logging and

alarm threshold, where xxx is a number between 1 and 1000, and

represents the threshold in 0.1% increments. Packet loss which exceeds

the threshold generates an SNMP trap and writes a message to the log file

if logging is enabled. The default value is 10 (1%).

Transfer files using the CLI

A number of special file transfer commands are available to Put/Get files

from the IPL> CLI. These commands are normally used as part of an expert

support procedure if OTM or Element Manager are not available.

These commands, listed in Table 77, are from the perspective of the Voice

Gateway Media Card. If “Get” is part of the command, the file is transferred

from the OTM PC to the Voice Gateway Media Card. If “Put” is part of the

command, the file is transferred from the Voice Gateway Media Card to the

OTM PC.

To transfer a file, enter one of the commands in listed in Table 77 at the IPL>

CLI, depending on what type of file transfer is to occur.

Table 77 lists the commands can be entered at the IPL> CLI.

Table 77

IPL> CLI Commands – file transfer (Part 1 of 2)

Command Parameters

swDownload <hostname> <username> <password> <directory path> <filename>

configFileGet <hostname> <username> <password> <directory path> <filename>

bootPFileGet <hostname> <username> <password> <directory path> <filename>

hostFileGet <hostname> <username> <password> <directory path> <filename>