Page 304 of 910 Installation and configuration summary
553-3001-365 Standard 4.00 August 2005

Installation summary

The following summary of steps can be used as a reference guide to install
and configure an IP Telephony node and Voice Gateway Media Cards on a
system. This summary is intended to serve as a pointer to the more detailed
procedures contained in other chapters and to provide a sequential flow to the
steps involved in the overall installation procedure.
Note: Complete all installation and configuration steps before
transmitting data to the Voice Gateway Media Cards.
1Complete the Voice Gateway Media Card installation summary sheet.
See Table 57 on page 307.
2Complete the IP Phone configuration data summary sheet. See Table 58
on page 308.
3Install the hardware components:
a. Install the Voice Gateway Media Card(s). See Procedure 14 on
page 316 for installing the ITG-P 24-port line cards and Procedure 16
on page 324 for installing the Media Card 8-port and 32-port line
cards.
b. Cable the Voice Gateway Media Cards:
i. Install the ELAN subnet, TLAN subnet, serial interface cable for
the ITG-P 24-port line card. See Procedure 18 on page 332.
ii. Install the Shielded 50-pin to Serial/ELAN/TLAN Adapter for the
Media Card 8-port and 32-port line card. See Procedure 19 on
page 336.
4Configure IP Line data on the system:
a. Configure the IP address for the ELAN network interface. See
Procedure 20 on page 337.
b. Configure VoIP bandwidth management zones. See page 338.
c. Configure IP Line physical TNs. See page 342.
d. Configure virtual superloops. See page 347.
e. Configure Small System (if applicable) mapping of virtual superloops.
See page 348.
f. Configure IP Phone features. See page 351.