Page 316 of 910 Installation and initial configuration of an IP Telephony node
553-3001-365 Standard 4.00 August 2005
Procedure 14
Installing the ITG-P 24-port line card
1For each ITG-P 24-port line card in the node, identify the IPE card slot
selected for the ITG-P 24-port line card. Use the information from the
“Voice Gateway Media Card installation summary sheet” on page 306,
and Table 57 on page 307.
Note: Even though the ITG-P 24-port line card is a two-slot card, only the
left slot is counted for the card slot number. For example, for an ITG-P
24-port line card installed in slots 2 and 3, the slot number is 2.
2Remove any existing I/O panel cabling associated with any card
previously installed in the selected card slot.
3Insert the ITG-P 24-port line card into the card guides and gently push it
until it makes contact with the backplane connector. Hook the locking
devices.
Note 1: The red LED on the card faceplate remains lit until the card is
configured and enabled in the software, at which point the LED turns off.
Note 2: The faceplate display window displays start-up self-test results
(T:xx) and status messages. A display “F:XX” indicates a failure of the
self-test. It is normal for the ITG-P 24-port line card to display “F:10”
during the start-up self-test. F:10 indicates that the self-test did not find a
Security Device. The ITG-P 24-port line card does not have a security
device.
Some failures indicate that the card must be replaced. See Table 79 on
page 689 for a list of the ITG-P 24-port line card display codes.
End of Procedure
Table 61
ITG-P 24-port line card installation by module type
Meridian 1 Modules ITG-P 24-port line card
NT8D37BA/EC IPE modules All available IPE card slots
NT8D37AA/DC IPE modules 0, 4, 8, and 12