Installation and initial configuration of an IP Telephony node Page 311 of 910
IP Line Description, Installation and Maintenance
• “Installing the Media Card” on page 324
• “Replacing the existing I/O Panel Filter Connector” on page 326
• “Installing the NTMF94EA ELAN, TLAN, serial interface cable” on
page 332 for the ITG-P Line Card
• “Installing the Shielded 50-pin to Serial/ELAN/TLAN Adapter onto the
Media Card” on page 336 for the Media Card
• “Configuring the ELAN network interface IP address for the active
ELNK” on page 337

Equipment considerations

This section lists the required and optional equipment that can be used to
install, configure, and maintain the Voice Gateway Media Cards and IP
Phone products.

Required equipment

The required equipment includes the following:
• a PC to manage IP Line 4.5, with the following installed:
— OTM 2.2 must be installed for a Meridian 1 system
— Internet Explorer 6.0.2600 (or later) to run Element Manager for
CS 1000 systems
• local TTY or terminal in a switch room. This is required for Leader
configuration.
• two shielded CAT 5 Ethernet cables to connect the Voice Gateway
Media Card to an external switch (recommended) or hub equipment
• 10/100BaseT network interface (optional auto-sensing) to support
TLAN and 10BaseT ELAN network interface connections
• 10/100BaseT network interface (optional auto-sensing) in each location
where an IP Phone resides
• serial cables