Page 684 of 910 IP Line administration using OTM 2.2
553-3001-365 Standard 4.00 August 2005
4The OTM site name, OTM system name, and customer number must
exist in the OTM Navigator before a new IP Telephony node can be
added.
Note: Ensure the system type is defined correctly.
Under Node Location in the Retrieve node window:
a. OTM site: Select the OTM Site.
b. OTM system: Select the system.
c. Customer: Select the Customer number.
d. Node Number: Ensure the node number is unique under the
customer number. Also, ensure that all IP Telephony nodes
connected to the same TLAN subnet have a unique node number
regardless of the OTM site, Meridian 1 system, and customer
number.
e. Active leader management (ELAN) IP: Enter the active Leader
management IP address field for the existing node.
f. SNMP community read/write name: Enter the SNMP read/write
community name.
Note: The SNMP read community name cannot be used.
5Click Start retrieve.
The results of the retrieval are shown under Retrieve control. The node
properties are retrieved from the active Leader. The card properties are
retrieved from Leader 0.
6Click Close when the download is complete.
7In the IP Telephony window, select the newly added node in the top part
of the window.
8Refresh the card status (View > Refresh) and verify that the cards in the
newly added node are responding.
A new node has been created by retrieving data from another node
9Double-click on the new node in the IP Telephony window. The Node
Properties window opens for the newly-added node.
10 Inspect each tab in the node properties and verify the data is correct and
consistent with the node from which the data was retrieved.