Configuration of IP Telephony nodes using Element Manager Page 403 of 910
IP Line Description, Installation and Maintenance
3Observe the Leader card faceplate maintenance display window.
When the display reads “T:20”, the card begins to send BootP requests
on the ELAN subnet. A series of dots is printed on the TTY.
4Type +++ to escape from the BootP request.
5At the Login prompt, enter the user ID and password to access the
IPL> CLI:
• If the card is a new card (out of the box), then the user ID is itgadmin
and the password is itgadmin.
• If the card has been previously connected to the Call Server, then the
user ID and password are the PWD1 of the Call Server.
• If the user ID and password are forgotten, see Procedure 71 on
page 558 to reset the IPL> CLI Shell username and password.
6When the maintenance window displays “T:21”, log into the IPL> CLI.
At the IPL> prompt, enter the setLeader command to configure the
Leader Management LAN (ELAN) network interface IP address,
Management LAN gateway IP address and the Management LAN subnet
mask:
setLeader “xx.xx.xx.xx”,“yy.yy.yy.yy”,“zz.zz.zz.zz”
Note 1: The three parameters must each be enclosed in double
quotation marks. There must be a space after the command and before
the first parameter. Put commas and no spaces between the following
parameters:
“xx.xx.xx.xx” = IP address.
Enter the same IP address that was entered in the Management LAN
IP address field for Leader in the Cards menu of the Edit window.
“yy.yy.yy.yy” = Gateway IP address.
Enter the same IP address that was entered in the Management LAN
gateway IP address field in the Node menu of the Edit window. If
there is none, enter the following: “0.0.0.0”
“zz.zz.zz.zz” = Management LAN subnet mask.
Enter the same address that was entered in the Management LAN
subnet mask field Node menu of the Edit window.
Note 2: This step assumes that the new IP Telephony node has already
been configured in Element Manager.
7Reboot the Leader Voice Gateway Media Card.