Page 496 of 910 Configuration of IP Telephony nodes using OTM 2.2
553-3001-365 Standard 4.00 August 2005
Note: The Node number is the same value as the value stored in the
Node number field in the main IP Telephony application window.
SNTP Client parameters
The following are the parameters for the SNTP Client:
•Mode: Can be configured as active or passive. The default is passive.
•Intervals (seconds): The range is 0 –2147483646. The default is 256.
•Port: The range is 0 – 99999. The default is 20000 + the Node number.
• SNTP Server IP address. The default is 0.0.0.0.
Note: The Node number is the same value as the value stored in the
Node number field in the main IP Telephony application window.

Transmit node configuration from OTM 2.2

to the Voice Gateway Media Cards

Before transmitting the node configuration to the Voice Gateway Media
Cards, ensure the following:
• Voice Gateway Media Cards and cables have been installed.
• ELAN and TLAN network interfaces of all cards are connected with
access to the IP network.
• IP Line 4.5 data has been configured in OTM 2.2.
• OTM 2.2 server is connected to the local ELAN subnet or to a remote
subnet with IP router access to the ELAN and TLAN subnets.
The IP Telephony node and card properties are configured using OTM 2.2’s
IP Line 4.5 application. The configuration data is converted to text files by
OTM 2.2 and is then transmitted to the Voice Gateway Media Cards.
The process consists of the following steps:
1Set the Leader 0 IP address from a TTY connected to the local RS-232
maintenance port. See Procedure 61 on page 497.
2Reboot Leader 0.