Configuration of IP Telephony nodes using OTM 2.2 Page 519 of 910
IP Line Description, Installation and Maintenance
The path and file name of the IP Phone firmware appears in the Firmware
location text box.
The IP Line 4.5 software determines the target IP Phone type (2001,
2002, or 2004) based on the firmware filename. A filename of the format
xx02xxx.BIN (where “x” can be any alpha-numeric character) represents
a firmware file for the Phase I IP Phone 2004. Similarly a filename of the
format xx03xxx.BIN represents a firmware file for the Phase I IP Phone
2002. A filename of the format xx04xxx.BIN represents a firmware file for
the Phase II IP Phone 2001, IP Phone 2002, IP Phone 2004, IP Phone
2007, and IP Phone Audio Conference Phone 2033.
8Click the Start transmit button to begin upgrading the IP Phone firmware
on the Voice Gateway Media Cards.
9Monitor progress in the Transmit control window. Confirm the card
firmware is transmitted successfully to all cards. Note any error
messages, investigate, correct any problems, and repeat card firmware
transmission until it is completed successfully on each Voice Gateway
Media Card.
The IP Phones continue to run the old firmware until each telephone
reregisters with a Voice Gateway Media Card that contains the new IP
Phone firmware.
Note: Commands are available from the IPL> command line to upgrade
a single IP Phone immediately, all IP Phones immediately, or schedule all
IP Phones to be upgraded at a later time. Before doing this, verify that
each card has the correct firmware version and check the date and time
on the node.
10 Select an IP Phone for test purposes. Telnet to the Voice Gateway Media
Card. Log into the IPL> command line, and enter the following:
iSetReset “xxx.xxx.xxx.xxx”
where xxx.xxx.xxx.xxx is the IP Address of the selected IP Phone.
CAUTION
Downloading an incorrect version of the IP Phone
firmware can result in extended service interruptions and
require special recovery procedures.