Page 762 of 910 Voice Gateway Media Card maintenance
553-3001-365 Standard 4.00 August 2005
3If the administrative password is enabled (PwdEna=Yes) and there is a
null (zero-length) password (the Pwd field is blank), then the IP Phone
cannot be installed on that Voice Gateway Media Card.
4Use the nodePwdSet “password” command to set the administrative
password and to enable IP Phones to be installed. Ensure the “password”
parameter is included.
End of Procedure

Maintenance telephone

An IP Phone functions as a maintenance telephone when the CLS is defined
as MTA (Maintenance Telephone Allowed) in the Multi-line Telephone
Administration program (LD 11). A maintenance telephone enables
commands to be sent to the system; however, only a subset of the commands
that can be entered from a system terminal can be used. To access the system
using the maintenance telephone, a Special Service Prefix (SPRE) code
(defined in the Customer Data Block) is entered and followed by “91”. To
enter commands, press the keys that correspond to the letters and numbers of
the command (for example, to enter LD 42 return, key in 53#42##).
The following overlays (LDs) are accessible from an IP Phone operating as a
maintenance telephone: 30, 32, 33, 34, 36, 37, 38, 41, 42, 43, 45, 46, 60,
and 62.
Note: The above maintenance overlay operations are supported on IP
Phones except for the Tone and Digit Switch (TDS) commands of LD 34
and TONE command of LD 46.
NodeI
D
=====
=
123
PwdEn
a
=====
==
Ye s
Pwd
======
==
TmpPw
d
======
==
Uses
=====
==
Timeout
==========
0d 0h 0m 0s