IP Line administration using OTM 2.2 Page 685 of 910
IP Line Description, Installation and Maintenance
11 Click the Configuration tab and ensure the Host names information, IP
addresses, and TN are consistent.
End of Procedure

IP Line CLI access using Telnet or local RS-232

maintenance port

There are two ways to access the IPL> Command Line Interface (CLI):
1Use the NTAG81CA cable to connect the DIN8 pin connector on the
faceplate, or the NTAG81BA cable to connect the DB9 I/O breakout
cable to the COM port of a local PC. Use a null-modem adapter to
connect a modem for remote dial-up access.
2Telnet to the card from the OTM IP Telephony window. This
automatically Telnets to the IP address of the Management interface
(ELAN) of the card. Alternatively, use the Telnet application on a PC and
manually enter the Management (ELAN) IP address, Voice (TLAN) IP
address, or the node IP address if trying to connect to the active Leader.

Telnet to a Voice Gateway Media Card

To access the CLI on a Voice Gateway Media Card from the OTM PC, follow
the steps in Procedure 103.
Procedure 103
Accessing a Voice Gateway Media Card using Telnet
1Click the Services folder. Double-click the IP Telephony icon.
The IP Telephony window opens.
2Right-click on the Voice Gateway Media Card to be accessed.
3Select Telnet to ITG card from the popup menu.
CAUTION
Do not connect two maintenance terminals to both
the faceplate and I/O panel serial maintenance port
connections at the same time.