Page 402 of 910 Configuration of IP Telephony nodes using Element Manager
553-3001-365 Standard 4.00 August 2005
address or Signaling Server TLAN network interface IP address. The
Voice Gateway Media Cards require a reboot only if the card network
interface IP address information has changed.
Transferring the configuration - second node
For a second (or subsequent) node, the process to transfer the node
configuration to the cards consists of the following steps:
1Configure the Leader IP address. See Procedure 36 on page 402.
2Transmit the node properties. Procedure 37 on page 405.
3Configure the Follower card. See Procedure 38 on page 411.

Configuring the Leader network interface IP address

Follow the steps in Procedure 36 on page 402 to configure the network
interface IP address of the Leader Voice Gateway Media Card.
Procedure 36
Configuring the Leader IP address for a second or subsequent node
1Access the IPL> CLI by connecting the COM port of a PC to the RS-232
serial maintenance port on the faceplate of the Leader Voice Gateway
Media Card with an NTAG81CA PC Maintenance cable.
If required, use an NTAG81BA Maintenance Extender cable between the
PC Maintenance cable and the PC.
Alternatively, connect the NTAG81BA Maintenance Extender cable to the
female DB-9 connector of the NTMF94EA ELAN, TLAN RS-232 Ports
cable for a more permanent connection to the Voice Gateway Media Card
serial maintenance port.
Note: Never connect two terminals to the faceplate and I/O panel
breakout cable serial maintenance port connectors at the same time.
2Use the following communication parameters for the TTY terminal
emulation on the PC:
• 9600 baud
• 8 bits
• no parity
• one stop bit