Nortel Networks 1000 Configure DSP profile data

Page 472 of 910 Configuration of IP Telephony nodes using OTM 2.2

553-3001-365 Standard 4.00 August 2005

f. Card TN: For Large Systems, enter Card TN (l s c) information. For

Small Systems and CS 1000S systems, enter two zeros followed by

the card slot number (1-50); for example, 0 0 49. The card TN format

is determined by the system type that is configured in the OTM

Navigator. Ensure the correct system type is entered in the OTM

Navigator before adding the node.

g. Card Type: Choose either Pentium or StrongArm. Select Pentium if

using a ITG-P 24-port line card (dual-slot card). Select StrongArm if

using a Media Card (single-slot card).

h. Click Add. The card role and address information appears in a

working list at the bottom of the New Node window.

i. Repeat the above steps for each card that is being added to the

node.

3Click Apply to add the card(s) to the Node.

Note: When Apply is clicked, the title of the window changes from New

Node to Node Properties.

End of Procedure

Configure DSP profile data

Procedure 53

Configuring DSP profile data using OTM

1Click the DSP Profile tab.

The DSP Options sub-tab opens. See Figure 149 on page 473.