Page 98 of 910 Features
553-3001-365 Standard 4.00 August 2005

Now the time-out and number of retries can be configured in the OAM and

PDT shells of the Signaling Server. See Table 14.

The RUDP Timeout and Retries Count commands are found in the usi group.

If Help is typed at the OAM prompt, the following is output.

oam> help
For help on a particular command group type: help 'group'
Available command groups are:
……
Table 14
RUDP Timeout and Retries Count commands
Command Description
usiSetPhoneRudpRetries Configure the RUDP Retries Count maximum
for IP Phones
1 – (10) – 20
See Note 1.
usiGetPhoneRudpRetries Display the RUDP Retries Count maximum for
IP Phones
usiSetPhoneRudpTimeout Configure the RUDP Timeout value (in
msecs) for IP Phones
50 – (500) – 1000in increments of 50
milliseconds
See Note 1.
usiGetPhoneRudpTimeout Display the RUDP Timeout value (in msecs)
for IP Phones
Note 1: If the customer has a network with low network delays, one or both parameters can be
reduced to make an IP Phone more responsive to failures. If the network delay values are high,
the parameters can be increased to prevent the IP Phones phones from being reset due to
significant network delay