Configuration of IP Telephony nodes using Element Manager Page 369 of 910
IP Line Description, Installation and Maintenance
Note 1: To log out of Element Manager, click Logout in the upper
right-hand corner of the window.
Note 2: When working in the IP Telephony > Node: Servers, Media
Cards > Configuration > Edit window seen in Figure 85 on page 374,
Element Manager times out after a period of inactivity. Users are
prompted with a warning five minutes before Element Manager times out.
If the user clicks OK within the warning time out period, the timer is reset.
If the user does not respond, the session is cancelled and the user is
forced to login again. Any data that was modified, but not submitted, is
lost.
Figure 82
Timeout message
End of Procedure

Summary of procedures

The following is the summary of the steps required to configure a node and a
Voice Gateway Media Card using Element Manager:
1“Manually add an IP Telephony node” on page 370
2“Configure SNMP trap destinations and community name string access”
on page 375
3“Configure Voice Gateway Profile data” on page 379
4“Configure Quality of Service” on page 385
5“Configure ELAN IP address (Active ELNK), TLAN voice
port, and routes (Small Systems and CS 1000S only)” on page 387
6“Configure file server access” on page 392
7“Configure loss and level plan” on page 394