Page 804 of 910 Voice Gateway Media Card maintenance using OTM 2.2
553-3001-365 Standard 4.00 August 2005
11 Change the Management MAC to the MAC address of the replacement
Voice Gateway Media Card. The MAC address is the Motherboard
Ethernet address labeled on the faceplate of the replacement Voice
Gateway Media Card.
12 Click Change, and then OK.
13 Select Leader 0 or any Voice Gateway Media Card in the node in the
IP Telephony window.
14 Use the Configuration > Synchronize > Transmit. The Transmit
Options window opens.
15 Under Transmit options, select the Transmit to Selected Nodes radio
button and check the Node Properties to Active Leader check box.
16 Click Start transmit. This updates the node properties on the active
Leader card with the MAC Address of the replacement Voice Gateway
Media Card. The results of the transmit are displayed under Transmit
control. When the transmit is successful, click Close.
17 Install the replacement Voice Gateway Media Card into the card slots in
the Meridian 1/CS 1000M IPE module, Option 11C/CS 1000M Cabinet,
CS 1000E Media Gateway 1000E/Media Gateway 1000E Expander, or
CS 1000S Media Gateway 1000S/Media Gateway 1000S Expander. To
do this:
a. Pull the top and bottom locking devices away from the card faceplate.
b. Insert the Voice Gateway Media Card into the card guides and gently
push it until it makes contact with the backplane connector. Hook the
locking devices.
Note 1: When cards are installed, the red LED on the faceplate remains
lit until the card is configured and enabled in the software, at which point
the red LED turns off. If the LED does not follow the pattern described, or
operates in any other manner (such as continually flashing or remaining
weakly lit), replace the card.
18 Observe the faceplate maintenance display to see start-up self-test
results and status messages. A display of the type F:xx indicates a
failure. Refer to Table 79 on page 689 for a listing of the ITG-P 24-port
line card’s display codes and to Table 80 on page 691 for a listing of the
Media Card’s display codes.