Page 324 of 910 Installation and initial configuration of an IP Telephony node
553-3001-365 Standard 4.00 August 2005

Install the Media Card

To install a Media Card, follow the steps in Procedure 16.

Procedure 16
Installing the Media Card
1For each Media Card in the node, identify the IPE card slot selected for
the Media Card.
Use the information from the “Voice Gateway Media Card installation
summary sheet” on page 306, and Table 57 on page 307.
2Remove any existing I/O panel cabling associated with any card
previously installed in the selected card slot.
3Insert the Media Card into the card guides and gently push it until it makes
contact with the backplane connector. Hook the locking devices.
Note 1: The red LED on the faceplate remains lit until the card is
configured and enabled in the software, at which point the LED turns off.
Note 2: The card faceplate display window displays start-up self-test
results (T:xx) and status messages. A display “F:xx” indicates a failure of
the self-test. Some failures indicate that the card must be replaced.
Note 3: Refer to “Transfer node configuration from Element Manager to
the Voice Gateway Media Cards” on page 401.
Note 4: Refer to Table 80 on page 691 for a listing of the Media Card
display codes.
End of Procedure
Table 62
Media Card installation by module type
Meridian 1 Modules Media Card
NT8D37BA/EC IPE modules All available IPE card slots
NT8D37AA/DC IPE modules 0, 4, 8, and 12