Page 670 of 910 IP Line administration using OTM 2.2
553-3001-365 Standard 4.00 August 2005
18 Transmit the node or card properties to the Leader 0 card.
Select the Leader 0 Voice Gateway Media Card in the IP Telephony
window.
19 Click the Configuration > Synchronize > Transmit.
20 To transmit to the node, select the Transmit to selected nodes radio
button. Check the Node Properties to Active Leader check box.
21 Click the Start transmit button.
The results of the transmit appear in the box under Transmit control.
Verify that the properties are transmitted successfully. If the transmit is
unsuccessful, click the Start transmit button again.
22 Log into LD 32 and disable the cards using the DISI command.
23 Click the Configuration > Synchronize > Transmit.
24 Select the Transmit to select cards radio button.
25 Click the Start transmit button.
The results of the transmit appear in the box under Transmit control.
Verify that the properties transmitted successfully. If the transmit is
unsuccessful, click the Start transmit button again.
26 Click Close when the properties are successfully transmitted.
End of Procedure
If changes are made to the
__________ tab...
... then transmit
___________ properties.
General tab
Note: If changes are made to the
System Name, System Location, or
System Contact in the Hostname
Config window (Host Names button),
the card properties must be
transmitted.
node properties
Configuration tab node properties
SNMP Traps/Routing and IPs tab card properties
Ports tab card properties