Installation and initial configuration of an IP Telephony node Page 333 of 910
IP Line Description, Installation and Maintenance
Note 1: The switch LEDs and the faceplate link LEDs light when the card
is connected to the WAN/LAN through the TLAN network interface.
Note 2: Refer to Converging the Data Network with VoIP (553-3001-160)
for more information about engineering and connecting the LAN/WAN.
End of Procedure
Install the Shielded 50-pin to Serial/ELAN/TLAN Adapter
The Media Card can support a single connector solution for access to the
TLAN and ELAN network interfaces. This connector (see Figure 68 on
page 334) is called the A0852632 Shielded 50-pin to Serial/ELAN/TLAN
Adapter. It replaces the single NTMF94EA ELAN, TLAN, RS-232 Serial
Maintenance I/O interface cable (‘octopus’ cable).
The adapter breaks out the signals from the I/O connector to the following:
• ELAN network interface
• TLAN network interface
• one RS-232 (local console) port